Garage Doors in Sunnyside, OntarioThe whole door,not just the loud part.
When a technician arrives at a house in Sunnyside, the first job is to walk the whole door, from the bottom seal to the header bracket, because the part that made the noise usually has a worn neighbour. Fixing both on one visit means the door stays fixed instead of failing again next month.
Sunnyside
Ask us to look at your door in Sunnyside.
Our technicians treat a door in Sunnyside as a system: springs, cables, drums, rollers, tracks, opener and sensors all affecting each other. A repair that ignores the neighbouring parts fails early, so we check the lot, fix what is worn, and tell you honestly what is fine and can wait.
— Parkdale Garage Door Services
- A walk-through of the doorYou see what we see: the spring that has stretched, the cable that is fraying, the sensor that is knocked off line.
- Care for what is storedBikes, tools, seasonal boxes and vehicles are moved or covered as needed, and put back where they were.
- Choices that fit your plansSelling next year, staying for decades or renting out: the right option depends on that, and we ask before advising.
Hours
- HoursOpen 24/7
- Nights and weekendsSame fees
- In business35 years
- VisitsOn-site assessment
Garage door services
Where to start
The garage door services we bring to Sunnyside fall into four groups: repair and maintenance for doors that are sticking or noisy; springs and lifting hardware; openers, remotes and access; and new door installation or upgrade for homes and businesses that are ready for a change.
Sunnyside
Garage Doors · Sunnyside
Garage Door Perimeter WeatherstripDry leaves keep appearing in the same corner inside the garage, and this fall there were mouse droppings along the wall beside…
Garage Door Roller ReplacementHalfway up, the door hesitates and the opener strains before it carries on.
Garage Door Cable ReplacementThe cable has wrapped itself around the shaft above the door instead of sitting on its drum.
Garage Door Opener Diagnosis and RepairFor a few days there was a grinding sound whenever the door started moving.
Chain-Drive Opener RepairThe chain in the detached garage went orange with rust over the winter, the links are stiff, and the opener strains and groans to…
Belt-Drive Opener RepairThe belt looks fine from a distance, but up close the rubber has cracked across the back in dozens of places and, in one spot…
Smart Garage Controller SetupA smart hub arrived in the mail with a coin-cell sensor and two wires.
Full-View Glass Garage Door InstallationYou like the brightness of clear glazing but not a direct view of everything stored inside.
Commercial Rolling Door RepairThe labelled rolling fire door still moves from its control, yet the release assembly and closing path were disturbed during…
High-Lift Garage Door ConversionYou want to keep the sectional door, but its standard track layout conflicts with a renovation above the parking bay.
Springs
Springs & Hardware
Cold snaps take a toll on springs already near the end of their life. A coil that was hanging on through the summer often lets go on the first hard frost.
- The roller at the top of the second panel is leaning outward and only half of the wheel is still in the track.Garage Door Hinge Replacement
- After a decade of slushy winters the bottom foot of the track is flaking rust.Garage Door Track Repair or Replacement
- Nothing broke outright, but the door has grown heavier each winter, opens more slowly and squeals as it moves.Torsion Spring Replacement
- It is the first hard frost of the year and the door on the old detached garage has stopped halfway, squealing at one…Extension Spring Replacement
- You pulled the red cord to move the door by hand during the power cut, lifted it to about waist height and let go.Garage Door Balance Adjustment
Openers
Openers & Access
Belt drives are quiet, chain drives are sturdy, and wall-mounted units leave the ceiling clear. Choosing among them depends on the door, the room above the garage and how you use the space.
Toronto, Ontario
Sunnyside information
- Town
- Sunnyside, Toronto, Ontario
- In business
- 35 years
- Hours
- Open 24/7, same fees any hour
- Phone
- (289) 804-6089
- Visits
- On-site assessment preferred
2021 census · what it means at the door
58%Older homes
About 58% of homes in Toronto were built in 1980 or earlier, according to the 2021 Census.
Older garages tend to have lower headroom and narrower single openings, so replacement doors and openers are chosen to fit the space rather than the other way round. Measuring the header, side room and ceiling depth is the first step on every one of these visits.
23%
Single-detached houses make up about 23% of homes in Toronto (2021 Census).
In attached housing, a resident's remote or fob may open both their own door and a shared gate, and lost devices are a real security concern. We clear old codes from the operator, program replacements, and explain to management how to keep the access list current.
Which fix fits?
The new door went in last year and looks perfect, but the old wooden stop and its tired seal were left in place.The usual fix
UsuallyGarage Door Perimeter Weatherstrip
WhyA perimeter seal is only as good as the door it meets, so a technician looks at the door before the seal.
A roller near the top corner is riding on the lip of the track rather than inside it, and the section above leans back a little more each week.The usual fix
UsuallyGarage Door Roller Replacement
WhyNot every roller suits every door.
The door went up as usual this morning, then stopped a third of the way with one corner higher than the other.The usual fix
UsuallyGarage Door Cable Replacement
WhyWhich counterbalance your door has shapes the job.
It is a January morning and the door lifts about a hand's width, groans, and settles back down.The usual fix
UsuallyGarage Door Opener Diagnosis and Repair
WhyEvery diagnosis ends with the same two tests, because an opener that moves the door is only half fixed.
Asked and answered
Will a new seal make the room above my garage warmer?
It can help. Drafts around the garage door cool the garage, and the garage cools the floor above it and the wall it shares with the house. Closing the perimeter cuts those drafts, though how much warmer the garage runs depends on the door's own seal, the ceiling insulation and how the space is heated, not the perimeter alone. A technician can talk through those as separate steps if the room stays cold.
What is checked after the rollers go in?
The door is run through several cycles with the technician watching each wheel stay seated, then balanced by hand with the opener released to confirm it holds at halfway. The top section is checked for a tight seal at the header, the hinge and bracket fasteners are snugged, and the opener's force and reversal are tested with a 1-1/2 inch block in the door's path. The industry checklist for a residential door covers exactly these points, and they are all part of finishing the job.
What stops the door from falling if a cable lets go?
It depends, and not reliably. The other cable and its spring may hold that corner so the door tips and wedges in the track rather than falling square, and the rollers binding can add some resistance, but neither is dependable: the door can still drop unexpectedly on the failed side. Some doors also carry a broken-cable device on the bottom bracket that grips the track if a cable fails. Because the door may not be held at all, the technician clamps and supports it before doing anything else.
Will the repair happen during the same visit?
When the cause is a common part carried on the truck, yes: capacitors, gear kits, sensor pairs, trolleys, wall controls, remotes and wiring are typical. When the part is specific to an older model and has to be ordered, or when the diagnosis finds a spring or cable problem that needs its own appointment, the door is left safe and the next step is agreed with you before the technician leaves.
Is a chain drive supposed to be this noisy?
A chain drive has a steady mechanical sound that a belt drive lacks, and that much is normal. What is not normal is change: a slap along the rail from a loose chain, a clack at one spot from a worn sprocket tooth, grinding from the head as a gear wears, or a rattle from hangers or a header bracket that have loosened. Each of those has a fix, and a repaired chain drive should sound the way it did when it was new.